HOW DO I MAKE PVC RAILS!!!!

dont do it theyre way, take a board, cover the top with formica, then use pvc as coping on the side, make sure ur coping is like a lil above the formica surface and screw it on from the side. its perfect.

 
take a big ass drill bit into the side and then a smaller one through the hole and into the wood that you want to connect it to. screw it in. do this like every 2 feet or less. take a file and soften the hole and the ends of the pipe they can wreck your bases if you fall or you dont drill it right. i suggest making a frame out of 2x4's that is triangular its really stable. also take the same big ass drill bit into the bottom of the frame and buy some 10 inch spikes to hammer into the snow or ground so the rail doesnt move if you slide off the side early. thats how i do it at least, but there is tons of ways. find some scrap wood and pipes and experiment a little i did that till i figured that out
 
well for a rail out of one piece of pvc, take like a 3x3x whatever length you want piece of wood, and screw two or three flat boards perpindicular to it. Then take a one and a half inch pipe, and for every screw hole you want to make, drill a large enough hole that you can fit you bit into it in the top of the pipe. Then stick your bit through the hole you made, and screw the pvc to the wood. View attachment 370956
 
1. Buy PVC

2. Buy wood 2x4's and shit

3. Get tools

4. Construct it

5. Wtf is it really that complicated?

6. Why is there even a 6th step?
 
1. drive to home fucking depot

2. buy pvc and shit

3. put that shit together

4. jerk off

5. wait for snow

6. session that bitch

7. repeat step 4 if necessary

 
Build wooden box and drill a thick pvc and build a drop in ramp and lay it with turf. I had three when i used to live in vegas
 
It's not that complicated. Build a frame out of 2x4's and attach PVC pipes to the top. It took ms like 30 minutes to build one without any directions
 
You must log in or register to reply here.
Back
Top