When making a pvc pipe rail/box how do i screw the pvc on

TYW

TYW

Member
I am working on making a pvc rail but i do not know how i should screw in the pvc to the wood.
 
screw it up threw the bottom, or drill a hole in the top and just drop the srew down through the hole if that makes sense
 
What i did was I took a 4X6 and drilled a hole thru it and then drilled a hole thru one half of the pvc tube. Then i took a bolt and put it thru both and put a washer and nut on the end to keep it in place
 
drill larger holes on top, drop in screw and drill through into wood. bevel edges of top holes or sand them. also....searchbar////build a jib 101 cult broski
 
Drill in on the sides. Or better yet, throw away your pvc and get a rail welded for you, pvc gets too cold and shatters really easily. Already broke one this year.
 
when me and my friends made ours we put wooden dowels in the middle of the pvc and then drilled up from the bottom
 
how i did mine. i cut holes in the sides, and drilled at an angle thru the bottom. check da pic. also screws also go allthe way down, but i just drew it like that to show the screw angles and shitttt

r.png
 
You must log in or register to reply here.
Back
Top