Shop messed up?

lyndon

lyndon

Active member
messedup00017nz.jpg


messedup00021jn.jpg
 
It looks like that, but I'm not sure, because I don't have look bindings, so I don't know if they go like that. Try hammering them.
 
I don't really know what to do. Maybe you should mount them again in some ski-center. I shouldn't cost much.
 
take it back and show them and they'll tighten it, however ask to watch them do it because if they drilled to shallow and they try to force the screw down it will strip possibly and you want to see if it does so you can call them out on it. In fact ask them first if they drilled with the 4.1 or not. They should have and if they didn't you may have problems later on. If the screw kepps turning without getting tighter it's for sure stripped and the toe is that much more likely to come out when skiing hard.
 
"hammer it"....HAHAHAHAHAHAHAHAHA. Just when I thought NS couldnt be any more retarded...
 
doesn't need a remount. more like a screwdriver, but thats besides the point. just take them in and they will fix them for free. try not to be a dipshit when you talk to them. polite and courteous gets you a ton farther than retarded anger and accusations.
 
It's a few turns of a posi-driver, or less than a second with a screwshooter. It might be a mistake, but it most likely requires a little bit of tightening, and not a remount.

Be nice, just ask them what's up, and they'll gladly fix it.

Or, be a jackass and they'll "fix" it. I don't recommend being a jackass.
 
I had the EXACT same problem with my Scratch 200 bindings (almost identical binding).

I took it back the the shop, asked nicely, talked to the head shop tech and he fixed it no questions asked, and said if I had any more problems to come back and talk to him.

the glue has probably dried leaving a bulge in between the binding and the ski. On mine he removed the screw, scraped the glue out, and replaced it with a brand new screw. I think it's the way to go, and now it's nice an flush. Your gap us bigger than mine was so DEFINITELY take it to the shop.

Nice set up by the way.
 
The hole was probably not drilled deep enough. Use a screw driver to tighten, if you hear cracking thats what it is then take to shop. Or you can just hammer it.
 
ah....gotcha, they ARE The same bindings...I have last years in the purpleish colour that matched last years scratches.

255_429.jpg


to tell you the truth, I like the colour of yours WAAAAAY better.
 
You must log in or register to reply here.
Back
Top