Rossi Axial 2 brake help

Commonwealth

Commonwealth

Active member
I just clicked into my bindings for the first time since April. When I was putting my skis away I noticed that the spring detached from the brake. I had trouble getting it in, so I'm wondering if snapped a pin or something that holds the spring in the brake piece.

This is what it looks like now:

dsc0033lq.jpg


I tried to hold a piece of paper so you can see where a tiny hole is, I'm assuming its for a pin of some sort.

dsc0037xy.jpg


This is what it is supposed to look like:

dsc0039ey.jpg


If I can't get the spring back in, how do I take to entire brake off of the plastic piece that goes under the heel of my boot? I'm willing to go brake-less until I get home.
 
This is what it looks like now:

dsc0033lq.jpg


I tried to hold a piece of paper so you can see where a tiny hole is, I'm assuming its for a pin of some sort.

dsc0037xy.jpg


This is what it is supposed to look like:

dsc0039ey.jpg
 
Bump, to get above the four Jiberish threads that are already above this. If possible, I'd like to get this fixed promptly & for. I want to get a couple of days in before I go home for break.
 
it looks like your bindings have a boner. the same thing to my axials when i tried pulling my ski out of the water at the water ramps. it got caught under a step and just broke. i think a replacement peice for that is like 15$ though
 
Hmmmm....any idea on how to take the whole brake out then?

Hopefully this works. 1) for ze lazies and 2) to redeem myself somewhat.

dsc0033lq.jpg


Pin hole

dsc0037xy.jpg


Supposed to be

dsc0039ey.jpg
 
Wow guys - you've outdone yourselves this time. There are now NINE Jiberish threads above this one.

Only one Saga thread though...you're slacking.

Bump for a broke college kid that just wants to ski.
 
you have to use something as a pin, cut a finishing nail about 1 cm long, put it threw the hole on the piece that is standing straight up, take the brake pad, you have to pry the 2 metel L tabs that the post slides in between out from the plastic casing. push the nail and post into the L Tabs from the top and squish the L tabs and casing back together with pliers or a vice

i dunno how else to explain it.

look at the other one for refrence
 
Hmm, I figured there was a pin of some sort. But I'm in a dorm so I don't have anything to use, so I guess I'll just run it down to the shop...hopefully they don't charge me $20 or something stupid like that.
 
You must log in or register to reply here.
Back
Top