Public Enemy Problem

steve-o

steve-o

Member
So im head to the car at tremblant about the 5th time on my public enimies, and i look down, horrified to see a piece about 4x1 inch of my topsheet laminate cracked backwards, its onlt in the topsheet, is this big enough to to worry about and take back to the shop, or should i just try to stick it back down and keep goin... anyone else had this problem, or have solution ideas? thanks...

 
yeh epoxy is the shit

Remember it's 10% equipment, 90% rider, and 0% what kinda jacket your wearing

I am a skier because skiing needs a future

Save correct spelling for school

Member Number 2511

 
yeah topsheets do come off but i'd just ride em

~-~-~-~-~-~-~-~-~-~-

'You can't argue with idiots, they drag you down to their level and then beat you with experience.'

'so basically i lost my penis trying to have sex with my cat' Misty7

'Who's not 18 yet? What? LA LA LA LA LA LA! I can't hear you.'~Jay aka rebel

 
nah duct tape looks cooler

See, there's three kinds of people: dicks, pussies, and assholes. Pussies think everyone can get along, and dicks just want to fuck all the time without thinking it through. But then you got your assholes, Chuck. And all the assholes want us to shit all over everything! So, pussies may get mad at dicks once in a while because pussies get fucked by dicks. But dicks also fuck assholes, Chuck. And if they didn't fuck the assholes, you know what you'd get? You'd get your dick and your pussy all covered in shit!
 
a little piece of tape would help protect it(as long as it is not bad)

---------------

Hey honey, take a walk on the wild side
 
yeah after the first few times on my PEs the top sheet was ptretty shitty but this is my second season on them and they ride as good as new

 
First off, make sure you document the problem and alert K2 customer service of it before you repair your skis. Then fix them ski them and send them in on warrenty after the season is over.

-schmies

 
Warm your ski up with a hair dryer first then put the epoxy on and C-clamp it tight. The heat will help the epoxy soak in and hold tight.

 
all public enemies have topsheet shreddage...but i haven't really seen anything that bad, epoxy it and if it happens again have someone at the shop look at 'em

*Laura*

my mom has like 15 prada bags........ ATLANTASKI

i've seen alotta real good bitches go down
 
Get a board to put under the C clamp on the base side. Reason being, if you put too much pressure on just a tiny area, you could come out with a nice indentation in your base the size of a quater, AND especially if youre using heat, becuase you might push out an edge too...

AbsoluteSkiShop.com
 
hey schmies are you allowed to give advice like this?

i hope harvey bans you just so i can piss on your digital grave.

~mommy
 
whenever somepart of my PE starts peeling off i rip it out

___________________________________________________

______

'send 2 mexicans over there they will take care of everything'-Ice-Is-Scary's thoughts on how australia should fix there population problem
 
You must log in or register to reply here.
Back
Top