My rail is too high

[396222687862]

Alright, so my rail has support beams that are 2 feet high, i made it in the summer, and realized its too big for summer setup, cause i need a huge fucking kicker. i have like 6 inch screws connecting the PVCplatform and the feet. so i dunno how i can cut it. any tips?

 

[Bloom.]

fix it

 

[BkCountrySkrMO2]

yea i have the same problem, i'm not sure what do you yet

 

[TylerS]

hAha

 

[birdshake]

if I understand it right...

take out the screws and cut the wood down and then screw it back in

post a picture though

 

[Goobie]

yup that should work

 

[line1260skier]

Yup sounds about right not that hard of a job.

 

[396222687862]

they are 6" long screws fucking way down there with rounded ends. that are under my pvc. theres no possible way.

 

[steevner]

cut the wooden supports a bit shorter then re-attach them

 

[JAYTRON]

how are the feet connected on it. If you can take the feet off it and cut the supports down you could make it shorter that way. and if that doesnt work just dig a hole under the feet and burry them down a little.

 

[skithesprings]

jea, mine was about 6 feet tall and i put it about three feet into the ground with only four 2 inch diameter steel pipes over 25 feet of rail for support. now i have a permanant handrail. no cement either and its still sturdy

 

[snowXrider540]

this is my plan for summer.