Mounting junior skis

Non_State_Actor

Non_State_Actor

Active member
I'm searching for info on mounting Armada Tantrum in 138cm. I'm mounting Marker Free Ten ID bindings (there aren't too many options for tweener bindings that will accommodate walk to Ride soles) and have both short and long screw sets. Does anyone have solid information on which set of screws I should use? Also depth or specs on the proper drill bit? Any help appreciated!
 
Does it not say it on the ski? If not I could probably find the ski tech instructions online somewhere.
 
If its a junior ski I'd go with the short screw. Most likely have a thinner core and unless this is a big boy no reason to do long screws
 
14340625:mystery3 said:
Yeah, they're black and the ID version for boot compatibility but same binding.
Click to expand...

Oh yeah. Idk what you needed template or screws? But last night I tried to mount those exact bindings, didn’t have the right drill bit but idk if there’s anything I can help with
 
14340630:AlexHallsEyebrow said:
Oh yeah. Idk what you needed template or screws? But last night I tried to mount those exact bindings, didn’t have the right drill bit but idk if there’s anything I can help with
Click to expand...

There's a template online...I'll see of i can track it down quickly.

I was really just trying to verify drill bit size and screw length. The ski is kind of a tween ski so I wasn't clear whether I should use adult or kid's screws/bit. There's no info on the topsheet. Sounds like it's the small bit and short screws, the bindings came with both short and regular length screws.
 
14340642:mystery3 said:
There's a template online...I'll see of i can track it down quickly.

I was really just trying to verify drill bit size and screw length. The ski is kind of a tween ski so I wasn't clear whether I should use adult or kid's screws/bit. There's no info on the topsheet. Sounds like it's the small bit and short screws, the bindings came with both short and regular length screws.
Click to expand...

Oh oh, yeah I couldn’t find the “exact” template but I found one that fit it, I can send you the size and specs later
 
14340695:AlexHallsEyebrow said:
Oh oh, yeah I couldn’t find the “exact” template but I found one that fit it, I can send you the size and specs later
Click to expand...

Thanks, I have the template on my laptop. It's a good one I'll try to send you the link later
 
Put one side of the screws into the binding and put the binding on the ski in a way that you can see how far the screws go into the ski.

It should be pretty clear which set to use, but if you post picture I can tell you.

If the junior screws are the right depth, you'll use the 3.5x7mm bit.

If the adult screws are the right depth, you'll use the 3.5x9mm bit
 
14341036:AlexHallsEyebrow said:
Lmao this is the one used but I didn’t find the “exact” one so I used the m series one because it had 3 holes,( same as the one pictured above, toe piece only has 3 screws) but I’ve got everything marked I just need to get a drill bit, but thanks!
Click to expand...

All good. The Free Ten ID I'm mounting has four holes in the toe and four for the heel. Good luck with your mount!
 
You must log in or register to reply here.
Back
Top