Marker Griffons Movement

adamwhit8

adamwhit8

Member
So, here is my dilemma guys.I just got some new full tilt boots that are 310mm bsl. However, in attempting to lock into my skis, I found that the length is a little to small (barely reaching) to hold the binding down. So -> the boot is too small in length for what the current marker griffon I have are set at. Now, I have remounted my ar7s twice already, and avoiding a 3rd would be ideal. I heard that the griffons have some slide room, so if anybody could help to describe how i could attempt to make the bindings bsl a bit smaller would be much appreciated!

+k for help thanks guys.
 
no its in the middle at the rear, im just unsure of how to slide it if you know what i mean, so no its not pushed all the way up
 
There is a screw at the back that is parallel to the ski that moves the binding forwards/backwards on the track, use thus to adjust accordingly to the ski
 
Just tried it and the entire binding came off the track :\\\ haha, what do i do now? im not sure how to tighten it or loosen it when it is on the track?
 
when you say remount do you mean drilled two sets of holes?and why did you have this done?

i would take them to a shop and see what they say.

note: every time you get new boots you should take them in to get teched to your skis.
 
the fella who mentioned the screw in the back is correct in that this is your only option left. Put your booth in the binding, then screw that motherfucker tight! ive done this before so if your entire binding is falling off when you do so, you may want to consider killing whoever sold you those bindings
 
You must log in or register to reply here.
Back
Top