Marker duke pt + kingpin

S

sashko

Member
Is it possible to install inserts for Duke PT and Marker King Pin for the same boot sole length and using the same mount point for both bindings? A set per binding (one for duke and one for kingpin)

Example, I have a ski, that I want to use with duke pt for the resort + side country days. But whenever I’m going to have a full tour day - change dukes for king pins and have a much lighter touring set up.
 
topic:severniy said:
Is it possible to install inserts for Duke PT and Marker King Pin for the same boot sole length and using the same mount point for both bindings? A set per binding (one for duke and one for kingpin)

Example, I have a ski, that I want to use with duke pt for the resort + side country days. But whenever I’m going to have a full tour day - change dukes for king pins and have a much lighter touring set up.
Click to expand...

You could potentially quiver killer one ski for both of those bindings but understand that you will 100% not be even close to the same spot on the ski because of the different hole patterns. One would be at recommended and the other would be super far forward or super far back.
 
14220529:animator said:
You could potentially quiver killer one ski for both of those bindings but understand that you will 100% not be even close to the same spot on the ski because of the different hole patterns. One would be at recommended and the other would be super far forward or super far back.
Click to expand...

Then, could I install inserts for duke on recommended and inserts for kingpin 1cm behind the recommended mount point?

p.s. does anybody have templates for these bindings? I can’t find anything for dukes, and can’t find for kingpin in good quality(
 
yes it seems quite possible, ref same pattern, I will outlay it on the ski I have the PT's on now... just give me a few more days, still cant move much ref bad knee :|

Im thinking about doing this to my blaze 106, 186cm.
 
just measured it out, YES its possible, definetly

just put a kingpin on one ski and duke pt toe on other

Basicly you use same holes for both toe pices, and different ones for rear

Just mounted up some Blaze 106, damn the woodcore is so thin , its also a SPUNGE for the epoxy, I usually use 1 packet for 1 pair of skis, but it took 2 packs! just for the kingpins 9 holes vs 8 but still.
 
You must log in or register to reply here.
Back
Top