Lesson learned

T

tribefan226

Active member
always make sure your rails are well supported. in this case both my rails were/still are well made. but i set them up in a kinda sketchy flat-down. i set up the first rail a little ways up the hill then put a table at the bottom of the hill and put the other end of the rail on top of it so it was flat. then i put the other rail going down off the other side of the table. well long story short eventually the flat rail slid off the table(with me on it) and my front bood went smack into the front of the down rail and i ate major shit. like head over heals double eject shit
 
well they're two flat rails and i just kinda mix it up with how i set them up. i think im gonna use duct tape next time i do something with the table
 
You must log in or register to reply here.
Back
Top