Is my toe piece broken? (pics)

T

twsnow22

Active member
The part that holds my toe in is now upside down..not chill.. Ive had them go like sideways before..but never this.
1292306521009.JPG
1292306548010.JPG
1292306576011.JPG

 
Oh yeah that happened to me. They are designed to have a 180' release. You should be able to push it back into place
 
Yes you can actually fix that real easily.

Lower the din as far as it will go, if not farther. This will release the tension on the toe wings. Then just twist the wings right side up and re-tighten to appropiate DIN.

Afterwards, I would highly reommend getting the release tested at a shop just to make sure you don't place yourself in any unnecessary danger.

Good luck!
 
is that a px-series toepiece?i didnt know they could do that :)
but yeah, screw down the din, pop it right back and adjust, i had a similar thing happen with a toe wing on one of my marker bindings, it popped out to the side and wouldn't go back in, i lowered the din and snapped it back into place :)
 
This just happened to me today. Scared the shit out of me.

One of the plastic pieces on the sides of the toe piece chipped too. will that affect anything?
 
Nah man you should be fine if the chipping is minimal.

If you knocked the whole plastic wing extension thing off it may release funky on that side however.
 
Same thing happened to me, but it turned out my ski was snapped in half and my other bindings were fucked anyways, so it didn't really matter, but I'm pretty sure you can pop it back
 
You must log in or register to reply here.
Back
Top