How do I take apart my pivot 14?

[Mikeylal]

I need to install my pivot 14 on a ski that has inserts already put in, how do i remove the plastic peice to put in the first front 2 screws? on the heel peice

 

[Kolaczki]

check the maintenance thread yo

 

[jon@wh2o]

You don't. If you can't figure iT out just find a shop that will do it fir some beer

 

[no_steeze]

are these the silver turntable pivots or the old dildo heel pivots?

it should be very very straightforward on the turntables

 

[Bumblesteeze]

Whatever you do, watch your fingers!

 

[snocompton]

shop tech here.

you literally cant. 90% of bindings have parts on them that are designed to never come apart. most manufactures use rivets to secure their bindings together which are damn near impossible to remove. pivots are one of those bindings.

 

[DBL]

The half moon piece (semi circle with two hole.for screws on the turnables)?

 

[division.bell]

I may be misinterpreting what the OP is asking, but to me it sounds like he needs to retract the brakes in order to get the front 2 screws into place on the heel piece.

If this is the case, you don't take anything from the heelpiece apart, just hold the brakes up while you line up the screws and you should be good to go. I've found it helps to put the skis on a table and hold the binding down so the table helps hold the brakes up, allowing you access to the front holes on the heelpiece. This is what I do when I am removing FKS bindings to sell skis.

Hope this helps.

 

[Mikeylal]

thank u sir

 

[DR.SHRED]

do not liet the spring for the breaks come out what ver you do.