HELP!!!!!! I think I fucked my fks

[ANDR3WNEWELL]

I tried to take out the screw on the half moon on the heel to remove the break and I didn't know it was attached to the actual ski. I put it back in tight, will it still work? It was only one screw.

 

[a_burger]

depends on how gentle you were. If you didnt strip the hole then its probably fine

 

[ANDR3WNEWELL]

I saw a little bit of the screw had residue on it but only in one spot and it was only like in 2 sections of the screw

 

[Substitute]

I would take it back out and drop some epoxy or wood glue into it. Then put your screw back in and tighten it slowly.

 

[*Frankie*]

I would take it back out and drop some epoxy or wood glue into it. Then put your screw back in and tighten it slowly.

this. put a bit of epoxy on the screw or i the whole so it will bond again