Full Tilt owners help me out

I

iFail

Active member
I have Il Moros atm, and finally got the fit right by putting a custom footbed in the liners, and putting another flat thin footbed under the liner in the boot,(I am not using intuitions, they for some reason did not come with my pair) but they are just so heavy. I had tried FTs in the shop before I got Il Moros and they felt bad around my mid-upper shin, but I am thinking that was the liner because the shell fit seemed good. If I put a different liner in the same boot shell that fits me right, would that most likely make the fit right?

Also if I do get FTs, I would probably buy the #9 stiff tongue. Are all the boots literally the exact same other than the colors and tongues? I found some cheap Model A s( I think they are last years or something?) and was thinking I could buy those and buy the stiff tongues, and use my current liners/footbeds in them and that would give me the light good fitting boots I want. Also I ski a 28.5(326 BSL) Il Moro which is a tight fit, should I get a 29.5(325 BSL) FT?
 
Half the point of full tilts is the intuition liner, don't replace that. Intuitions are heat moldable so shin tightness would most likely go away. Amazing boots, very happy with mine, besides the buckles falling off.
 
a moldable liner doesnt add volume to the bottom of itself while molding. What I was doing is probably along the lines of a heel lift, so maby I should try that.
 
you are clueless about intuition liner.. they do add volume when being molded.

you can always do whatever you were thinking ho.

and other then a better liner, higher end model will have metal buckle this season, shock absorbing bed and a piece of fabric that lines up the cables.
 
You must log in or register to reply here.
Back
Top