FKS 155

A

artek

New member
Din display on my FKS 155 is broken , is there any way to figure out where is din 6 , the highest number visually on display ?
 
Is that not the lowest value on the binding? Just crank it all the way as far as it will go and you should be at 6 then
 
That's a pretty bad idea. OP, go to a shop and they can use the tester to figure out where you should be set. Also, I'm not sure why you need an FKS 155 if you're riding a din of 6. That would be at the very bottom of the range, and a 10 or 12 din binding would probably suit you much better. But whatever, do your thing man.
 
yes, it is lowest number in Dins , but it is higher when measure from the bottom, so when I turn

counterclockwise ,at some point I am reaching 6 Din ,not knowing, and I can still keep turning until screw

hits plastic cover , in this position boot is already loos in binding..

thank you for helping
 
You must log in or register to reply here.
Back
Top