Epic Idea!!!

Commonwealth

Commonwealth

Active member
OK, so I've been hearing a lot of talk about circle rails. I was just looking outside and I noticed my trampoline, which is partly disassembled. However, my trampoline is nowhere near anything close to a hill, I am proposing that some of you guys try to clean a trampoline rail. If you have a tramp, just take off all of the springs and the padding around the side and you have a circle rail!

P.S. - If you do it, post a vid!
 
its hard, the curves are pretty sharp, and the trnsitions between segemtns is pretty rough, but if you succeed, congrats.
 
do you know what would be REALLY cool? a circle rail only it got progressively lower so you could start and end at the same position, only you'd land lower on another platform of snow. i don't know if that's a good description, but try and imagine a spring cut so that the two ends exactly join up (360 degrees in total), and then make where you get on high and where you get off low.
 
A circle rail has been attempted by snowboarders a couple years ago; Nixon Jibfest video has footy of guys trying it but no one really got past half way
 
no that one was somewhere in organ and it only rotated 270 degrees, squaws was 360 degrees and only one random ass guy who worked in the parking lot got it
 
you could still do this epic idea of yours youd jut hafta bend it totally around so u wouldnt be slidin over the holes. it could still be an o rail just inside out
 
You must log in or register to reply here.
Back
Top