Edge Replacement Guide

[KickerTheCanMan]

I found this article while I was doing some Googling. Not that I'd recommend doing edge replacements yourself on most skis, if you had a pair that was strictly a rail pair and is damaged and you were handy with tools it could make a cool project. Have fun.

Edge Repair

'180 net grab = NOT a new trick!'

Have you ever seen a little kid slide back down the inrun of a kicker without going over? This is why parents shouldn't dump their kids off anywhere near the park...

 

[aclsarescary]

i only looked at the pictures, but in that last shot I bet they switched the skis with the non damaged ones.

 

[jfoust31]

no they didnt, u can see the lines where the new edge was put in moron

 

[CTD]

thats awasome. and yeah dumbass, a good tech can take a ski that is fucked, and make it look brand new.

Plain headband: 5

Plain hat: 15

Trim (any color(s)): free

Brim: 5

Earflaps, any size: 5

tassles: free

Dangly thingers: free

Fleece lining: 5

Embroidery: 25 cents per letter

hit me up! this is my lift ticket money.

 

[KeegLove]

bahahahhahahahah

SKI FOR LIFE!

WHITEWATER

 

[tandan83]

holy shit. they did a good patch job on that ski

free ipods for everyone!!!

 

[freeskier108]

I was thinking about taking some solder to the inside of the edge, and solder it to the new piece going in. That way theres no chance of it pulling out.

www.absoluteskishop.com

 

[KickerTheCanMan]

^ That's an interesting idea with the solder.

'180 net grab = NOT a new trick!'

Have you ever seen a little kid slide back down the inrun of a kicker without going over? This is why parents shouldn't dump their kids off anywhere near the park...

 

[CTD]

i tried that. doesnt do shit. its not strong enough. you would prolly just want to get some epoxy inbetween the edges, and sand off extra when you were done.

Plain headband: 5

Plain hat: 15

Trim (any color(s)): free

Brim: 5

Earflaps, any size: 5

tassles: free

Dangly thingers: free

Fleece lining: 5

Embroidery: 25 cents per letter

hit me up! this is my lift ticket money.

 

[PowderCanuck]

^yea that'd work better than solder, plus you wouldn't be burning your ski

______________________

Screw this I'm going skiing

 

[powwrangler]

I'd most likely use jb weld rather than epoxy.

 

[CTD]

i was gonna say that, but its basically the same thing as epoxy. there really wouldnt be much need to use anything else, cause if it was all consistant, it would be mutch stronger.

Plain headband: 5

Plain hat: 15

Trim (any color(s)): free

Brim: 5

Earflaps, any size: 5

tassles: free

Dangly thingers: free

Fleece lining: 5

Embroidery: 25 cents per letter

hit me up! this is my lift ticket money.

 

[Joemuench]

oooo that looks like a nice project but then again i have a hard time starting my homework. but skis cost a shit load so maybe id do that if my edge rip out. i wonder if you could fatter edges? i wonder if it would matter if a segment of the edge is beefyer that the rest of the ski.
http://profiles.myspace.com/users/9976723