Binding Question

Jules.

Jules.

Member
About to get a pair of lizzys mounted at dead center for a 335. on a px12. is there going to be a problem getting them adjusted at my 322 bsl? and if i have to remount will i be able to at dead center?
 
no and no

unless they were originally mounted while adjusted to the smallest they go then you should be fine, there's plenty of adjustability in a px12. if too small, you will most likely not be able to fit another set of holes in at dead center while keeping the new holes 1cm away from the old ones
 
so where would i get them mounted at? i really dont want to mount them back from center, but if its close i will i guess.
 
If you mount the PX12s for a 335 dead-center, they should adjust down to fit a 324.

But when you put the 324 in the bindings you will find yourself ~5mm ahead of center. Better to mount the PX12s for a 324 on center and adjust back to fit the 335.
 
yep take this into account. since the heel adjusts and not the toe it'll push the boot center forward if you move the heel forward a lot
 
You must log in or register to reply here.
Back
Top