Binding not flush with ski

froom

froom

Member
I just bought new 04/05 1080's and had the shop mount Rossi Scratch 200 bindings at core centre. Haven't skiid the setup yet.

The other day I was checking out the mounting job and realised that on the rear left screw of one of the toe binding, the binding isnt flush with the ski....maybe like 1-2mm off.

My question is this...can I just crank it in with a screw driver? Or will it fuck up the glue (i.e. break the seal). It also might bend the binding.

I expect that if I take it back to the shop it's exactly what they'll do.

How serious is it anyway? should I stop worrying and just ride em?

Thanks for the input
 
I don't quite understand what you are saying, but if there is a gap where you can see through that is NOT good. Take them back pronto. They will probably screw it tighter but at least if you rip it out later the shop was aware of the problem.

pictures?
 
bring em back for sure. whenever i mount a binding, that's something i make sure to avoid b/c it's no good.
 
take em back to the shop and let them fix them, then if the screws pull out or something when skiing its thier problem
 
You must log in or register to reply here.
Back
Top