Simple Re-Mount Question

Colin.W

Colin.W

Member
So i have a pair of 4FRNT TNKS from a couple years back that I had griffons on and then removed the bindings and out them on a custom pair of skis I made. Last weekend i ended up snapping one of the tails on my custom skis so I was wondering, Is it possible to just remount the griffons onto the 4FRNTS? will i need some epoxy or something to keep the bindings from falling out easily. I still have the same boot so I'm not worried about them not fitting my boots. Help = +K.
 
so you're saying I should use some epoxy? if I don't use epoxy should I be worried about the bindings un mounting?
 
If u use epoxy then the screws won't be budging so of you want to take the bindings off in the future you will struggle, I would just use some waterproof pva, as long as the screws are put in properly they will be fine and I wouldn't worry about them
 
Epoxy/woodglue would work fine.

Yeah they will probs un-mount easier, but go to your shop and get a hypercore or something thrown in their and it will work fine
 
In the past I've used a piece of a toothpick in the whole and some epoxy. Never had a pair rip out.

The tooth pick lets the screw grab into the ski a bit better instead of just sitting in the old threading.
 
woodglue but they have little plastic pieces that you have to put in the old holes, then hit them with a hammer so there in there and scrape off the top, fill the holes where the old bindings used to be is my point
 
You must log in or register to reply here.
Back
Top