Shifts brake bending?
- Thread starter BingPow
- Start date
Non_State_Actor
Active member
Should be a piece of cake.
Do you have the 100mm brakes on 112mm skis? Did they resize them at some point? You can shave the plastic off the inside part and get 2-3mm on each side probably.
Do you have the 100mm brakes on 112mm skis? Did they resize them at some point? You can shave the plastic off the inside part and get 2-3mm on each side probably.
maaattt
Active member
If it's the 115 width brake you will have no problems with a 117-118 width ski.
The skis taking a little bit of finangling to get apart when stuck together is regular across all widths of shift in my experience of mounting a bunch of shifts
I had 100mm width brake on a 108mm ski. Would have to finangle them apart like you are describing, but actual function outside of that was not effected
**This post was edited on Jun 18th 2022 at 12:30:35am
The skis taking a little bit of finangling to get apart when stuck together is regular across all widths of shift in my experience of mounting a bunch of shifts
I had 100mm width brake on a 108mm ski. Would have to finangle them apart like you are describing, but actual function outside of that was not effected
**This post was edited on Jun 18th 2022 at 12:30:35am