HELP: Removing Pole Grips

put the pole in a vice, get a wrench. hold the wrench right where the grip meets pole and hit it with a hammer. grips will pop right off
 
It's stuck on with a special glue. If you use a hair dryer to heat it up it will slide right off.
 
you need to make something solid in the shape of a U where it slides through the pole but not the grip. stick the pole into this U and then pull it hard and the grip should just pop right off. there is no glue holding the grip on, or just bring it to your ski shop and they will have this grip remover U thing im talking about. i wish i had a picture right now.
 
Somebody already asked this same question about 3 months ago. Don't listen to these other cats. YOu don't need a vise ar any special equipment. Soak the grips in really hot water for at least a half hour. THen gently twist and pull and the grips will slide right off.
 
If you want to take the poles off super quick without soaking them in hot water. You can grab a flat screw driver, CAREFULLY slid it down the grip and spray a little WD-40 down there and it will slid right off. And a little trick to get the grip back on the pole is to put a little rubbing alcohol in the grip slid it on, then knock it down. The rubbing alcohol evaporates so it won't get stuck in the grip and it makes er' super easy to slid on. Try that, it seems to work well for me.
 
if its aluminum then blow dry just below the grip on the pole for a while and then it should just slide right off...(use a vice too) if anything else.. blow dry the grip but be sure u don't melt it and then it should come off using a vice as well
 
you must work at a shop cuz i have the same thing at my work...and those shitty masters poles are the onlyones that have glue
 
yeah i did... and all this bullshit about soaking it and using a hair dryer is complete bullshit and a waste of time. they prolly wont even charge you if you just bring them to your shop anyways.
 
put it in almost boiling hot water (not boiling just ALMOST) then they will become loose and you just pull em off they should come off pretty easy...
 
ok, so once u get it off

how can i go about cutting down my poles?? just go at it with a saw? they are those bendy carbonfancythingers that isnt just plastic, woo i wanna shorten em
 
heat it up then put it in between a door and the wall so the door is clamping it and pull a couple times. the most important part is to heat up the grip. either that or lube it down with a buch of ky and it should come off easy
 
use an air gun and put it in the hole in the top after you pull the screw out the put the air on and pull the pole

i did it like 2 days ago and i worked
 
or just get a mini pole cutter its sweet, you just put it in the hole, twist the thing 2 times and then 2 more times and then *bing* it gives u an even cut
 
man i actually work in a ski shop as a tech... just put it in really hot water and it should just slip off, if it has glue you can just use a blowtorch or something to melt it most poles dont have glue though so it should just slide off
 
warm the pole up so the glue is ready to come out, carefully insert it in something just tight enough to catch the bottom lip of the handle, then just start jerk'n away. You'll pop your grip off in no time.

PS. this can be done alone but it's much more fun if you solicit the help of a spry young lass to do some of the jerking for you
 
You must log in or register to reply here.
Back
Top