Halp. mix/matching different px 12's

inactive

inactive

Active member
so, i busted the metal plates (on the heelpeice) on both of these
dynastar-px-12-jib-ski-bindings-2008_4906662_175.jpg

i have another pair of px 12's laying around, they are a bit different, but still same mold, still px12's. could i mount the heelpeices of one with the toepeices of the other?

 
well there are px 12's, px 12 ti's, and px 12 jib's, so just make sure they are both the same if you want to mix and match them. otherwise, the plates could be different heights (very minimally) and may make the boot a different height from the ski.
 
^how are they a piece of shit? did your brakes break because you landed wrong? if yes, did you bend the brakes to fit your skis? if yes, your problem with them is your fault.
 
nah it's not about the brakes they just pretty much fell appart and every week-end this winter (not kidding EVERY week end) I had to stop skiing and go get them fixed cause they would always have something that breaks then they would repair them and send them back and still be shitty. My friend who has them thinks the same. I have the scratch 120 if it changes anything
 
You must log in or register to reply here.
Back
Top