DIY ski waxing

Msteury

Msteury

Member
I just bought my first waxing and tuning kit !

how do I decide when my skis should be waxed and or tuned ?

Also any tips on the process are welcome .

thanks in advance

heres a little sliding we did in our B Y!!

[video]https://www.newschoolers.com/videos/watch/945252/trim-C004A890-84E0-4464-8F16-4B875913CE3A-MOV[/video]
 
In terms of when to wax. It really depends on how much you go out/what kind of conditions you're on. If its icy the wax will be stripped a bit faster.

Typically you can tell when a base needs wax. The colours start to look a bit dull, or if its black it gets white.

And always make sure the waxing iron is in motion.

All the best!
 
14078590:BlumpkinPumpkin said:
[tag=189437]@DominatorJacques[/tag]
Click to expand...

Yea. I have an ass-wipe of tuning waxing video. They be longer than most dudes thing-a-ma-jiggers!

From my channel one needs to search tuning, waxing, etc. Too many to list.

Have fun.

 
You can usually tell by looking at your ski bases. If the color is deep and vibrant you are typically good but when they start to look faded and dry you know its time for a wax. You can tell by touching them too. Feel your bases right after a wax job and after each time you ski and eventually you kind of get a sense for when you need more.

Also, when it comes time to scrape your skis after a wax. Make sure to put a tarp down to catch it all and make that your designated wax tarp. If your on carpet it will be impossible to get it out and if your on a hard floor the oils in the wax will make it really slippery nomatter how much you sweep it.
 
14078819:SuspiciousFish said:
if your on a hard floor the oils in the wax will make it really slippery nomatter how much you sweep it.
Click to expand...

How to kill your roomates that walk around in socks with 3 easy steps. Wax, scrape, await their immanent demise. Results guaranteed or your money back!!!

Also OP, it's pretty straight forward. Some people wax all the time but most generally just when the base starts to get dry. You'll feel it skiing and can see it looking at the base if it's pretty dry. As mentioned keep the iron moving to not burn your bases.
 
I scrape my base with my fingernail and see if I can see a mark. Though unless you shine a light on it and squint really hard this will probably lead to you waxing more than you need to. It'll be pretty obvious once you do it a few times. I don't scrape my bases cuz I wax more for maintenance than speed, and the snow will smooth it out after a few runs. Saves a lot of time and mess. A bunch of people smarter than me can probably say a bunch of reasons why that's bad tho
 
Thanks bro’s

wish me luck !

i love it dude !!

WALK THE WAX = Terminated

I can think of a few victims . ?
 
14078844:Msteury said:
Thanks bro’s

wish me luck !

i love it dude !!

WALK THE WAX = Terminated

I can think of a few victims . ?
Click to expand...

This reminds me of the old "Butter the floor" pranks that started showing up on youtube 10 years ago lol

 
14078819:SuspiciousFish said:
You can usually tell by looking at your ski bases. If the color is deep and vibrant you are typically good but when they start to look faded and dry you know its time for a wax. You can tell by touching them too. Feel your bases right after a wax job and after each time you ski and eventually you kind of get a sense for when you need more.

Also, when it comes time to scrape your skis after a wax. Make sure to put a tarp down to catch it all and make that your designated wax tarp. If your on carpet it will be impossible to get it out and if your on a hard floor the oils in the wax will make it really slippery nomatter how much you sweep it.
Click to expand...

I like this, but if you wait until "fade & dry" you might be too late. Once "burned" you will need to scrape away the burn, or it will just be right back after you ski the fresh wax again. You can't wax away burn!

Removing base burn is work. It can be done though.

[video]https://youtu.be/H96_dAgeHRs[/video]
 
14078836:abar. said:
I scrape my base with my fingernail and see if I can see a mark. Though unless you shine a light on it and squint really hard this will probably lead to you waxing more than you need to. It'll be pretty obvious once you do it a few times. I don't scrape my bases cuz I wax more for maintenance than speed, and the snow will smooth it out after a few runs. Saves a lot of time and mess. A bunch of people smarter than me can probably say a bunch of reasons why that's bad tho
Click to expand...

If you want proper base geometry and maximum glide, you must scrape and brush!

If all you do is hit rails...........well, there that is. If you jump, you might need speed to do the deed!

 
14078876:DominatorJacques said:
I like this, but if you wait until "fade & dry" you might be too late. Once "burned" you will need to scrape away the burn, or it will just be right back after you ski the fresh wax again. You can't wax away burn!

Removing base burn is work. It can be done though.

[video]https://youtu.be/H96_dAgeHRs[/video]
Click to expand...

Ahhhhh. This is the video I've needed for a year now.

I used to think waxing was only for racer dorks. Then when I started to have to buy my own skis and use them for more than a season, I began to take care of them. You may not notice initially, but keep riding then waxing. You'll pick it up and soon you won't be able to ride without that fresh slick glide you get from a pair of fresh whips.
 
14079006:Saucerboyshane said:
if your skis are sticky in snow, wax them.
Click to expand...

One needs a wax slightly harder than the snow to be skied.

One may have just waxed the skis, but if the wax is too soft the skis will "stick"

It's not just wax, it's the right wax for the condition and temperature of the snow.
 
Don't use too much wax. that's a really common mistake I see our new shop techs make a lot. they basically cover the base even before spreading with the iron. Then they spend the next 45 min scraping the base to remove the insane amount of wax they used. a double pass of the ski with a nice drizzle is what I do.
 
My wax kit came with a universal wax is that ok for southern Michigan? I’m not doing comp’s or anything like that?‍♂️ just ski for the fun!!!!!!

14079037:DominatorJacques said:
One needs a wax slightly harder than the snow to be skied.

One may have just waxed the skis, but if the wax is too soft the skis will "stick"

It's not just wax, it's the right wax for the condition and temperature of the snow.
Click to expand...
 
14079044:Msteury said:
My wax kit came with a universal wax is that ok for southern Michigan? I’m not doing comp’s or anything like that?‍♂️ just ski for the fun!!!!!!
Click to expand...

Wax is rated to certain temperatures. The packaging will say a range of temperatures that the wax is ideal for. If your typical temperatures are within the range your'e all set!
 
1. make sure the skis are warm. the warmer the better as itll open up the pores of the ski to accept in the wax.

2. match the wax iron temp to the temp recommended by the wax being used.

3. Follow Dominator Jacques videos
 
14079044:Msteury said:
My wax kit came with a universal wax is that ok for southern Michigan? I’m not doing comp’s or anything like that?‍♂️ just ski for the fun!!!!!!
Click to expand...

Might be fine for sometimes, but might need a harder wax if the snow is real cold, fresh, or man-made for sure.

When in doubt, always wax harder.

Air temps and snow temps are not the same.

Still, what sort of temperatures will you have on average for early season where you ski?
 
14079107:DominatorJacques said:
Might be fine for sometimes, but might need a harder wax if the snow is real cold, fresh, or man-made for sure.

When in doubt, always wax harder.

Air temps and snow temps are not the same.

Still, what sort of temperatures will you have on average for early season where you ski
Click to expand...

Normal temps are like 10 to 30 degrees Fahrenheit.

Harder wax as in colder temps or warmer ?

Are there more than one layer of wax you put on when you wax a ski like base layer vs finale coat? Just waxed my first pair of skis , looks pretty good , can’t wait to try them!!!!!

“ SHREDDIT!!!!”?thx guys.
 
14079142:Msteury said:
Normal temps are like 10 to 30 degrees Fahrenheit.

Harder wax as in colder temps or warmer ?

Are there more than one layer of wax you put on when you wax a ski like base layer vs finale coat? Just waxed my first pair of skis , looks pretty good , can’t wait to try them!!!!!

“ SHREDDIT!!!!”?thx guys.
Click to expand...

Go online to get these few waxes. Graphite Zoom & some Bullet.

For snow temps. above 18 F or so use the Zoom.

When it gets colder than that ad 50 to 60 % Bullet to the mix.

Can get here, but other places too.
https://the-raceplace.com/collections/tune-wax/products/dominator-zoom-wax?variant=24946075463
https://the-raceplace.com/collections/dominator-ski-wax/products/dominator-bullet-extreme-cold-wax

That said, you need a base prep. wax. This is the best. Use first thing to prepare and then from time to time.

Iron and cool with this wax at least three times. Then scrape and brush. Then wax away with the aboves.
https://the-raceplace.com/collectio...nator-renew-base-prep-wax?variant=24946082951

Dominator Zoom waxes are the best "all temp." aka "universal" waxes on the market.

Good luck.
 
step 1

let the wax drip on the skis

step 2

use the waxing iron to distribute wax

step 3

wait 5-10 minutes for wax to fully dry

step 4

scrape off excess wax with that scraper thing

step 5 use brushes from kit for finishing touch
 
14079207:sauce_man_steve said:
step 1

let the wax drip on the skis

step 2

use the waxing iron to distribute wax

step 3

wait 5-10 minutes for wax to fully dry

step 4

scrape off excess wax with that scraper thing

step 5 use brushes from kit for finishing touch
Click to expand...

5 to 10 minutes not nearly enough.

Wax needs time to re-organize it's molecular structure after melting by cooling.

Cooling time is important. Always cool at "room" tempatures. Never place ski in cold temps. to cool.

6 hours is best.

Minimum times. Soft=3 Hrs. Med.=2 Hrs. Hard=1 Hr. These are just approximate times.
 
14079222:DominatorJacques said:
5 to 10 minutes not nearly enough.

Wax needs time to re-organize it's molecular structure after melting by cooling.

Cooling time is important. Always cool at "room" tempatures. Never place ski in cold temps. to cool.

6 hours is best.

Minimum times. Soft=3 Hrs. Med.=2 Hrs. Hard=1 Hr. These are just approximate times.
Click to expand...

But if ur doing a diy quick wax five to ten is good
 
14079223:sauce_man_steve said:
But if ur doing a diy quick wax five to ten is good
Click to expand...

If you're in a hurry I guess. Otherwise give it some time. Go eat. Watch a movie. Play games. Etc. Then finish your skis
 
[tag=189437]@DominatorJacques[/tag] The real question is.... Do you know who is sending you THE POWDER?
 
14079433:P3t3r said:
[tag=189437]@DominatorJacques[/tag] The real question is.... Do you know who is sending you THE POWDER?
Click to expand...

No! It's still a mystery! Those be spendy mags. right there! Somebody gifted "The Jacques"
 
I like tuning up my skis I haven’t and won’t ever laugh at a white kid skiing that’s falls at the terrain park freeskiing isn’t for everyone.
 
14079600:Jibijsaga6 said:
I like tuning up my skis I haven’t and won’t ever laugh at a white kid skiing that’s falls at the terrain park freeskiing isn’t for everyone.
Click to expand...

What areeeeeee youuuu!?!
 
14079600:Jibijsaga6 said:
I like tuning up my skis I haven’t and won’t ever laugh at a white kid skiing that’s falls at the terrain park freeskiing isn’t for everyone.
Click to expand...

Hmmmmm....nice sentiment, but probably could have left out the "white" part.

Could it be I have fallen into the trap?

945597.jpeg
 
You must log in or register to reply here.
Back
Top