Anybody know how far ill have to move my mount switching from attacks to pivots

KCoCM

KCoCM

Member
If this is a dumbass question forgive me, but Id rather ask here than take them to the shop and have them tell me they need to pull the attacks off to line up the jig and see how the holes matchup. Does anybody know from experience how far the mount position needs to be moved swapping from attacks to pivots? I know the 5mm rule but wondering how the screw holes match up. someone make my day and tell me the screw holes line up perfectly so i dont haev to move the mount position at all
 
14391168:Biffbarf said:
Print out some templates and put them over each other for an idea
Click to expand...

This...I think there may even be a template that shows several popular mounting patterns superimposed atop one another. I'll see if I can find it.
 
14391214:mystery3 said:
https://drive.google.com/drive/mobile/folders/1lpDx4-8PF44Pc08HHNyYY6Gg2a3Dd245

All the way at the bottom

**This post was edited on Feb 4th 2022 at 1:35:18am
Click to expand...

/thread

thanks bro
 
That drive is the greatest Google drive to ever grace skiing

14391214:mystery3 said:
https://drive.google.com/drive/mobile/folders/1lpDx4-8PF44Pc08HHNyYY6Gg2a3Dd245

All the way at the bottom

**This post was edited on Feb 4th 2022 at 1:35:18am
Click to expand...
 
i went from fks mounted for 25/25.5 294mm bsl length and went down a full boot size (284bsl). current mount wouldn't work and remounting at center the holes were too close. ended up re-mounting with attacks and was perfectly fine....you should be good
 
14391652:isaacwrong said:
i went from fks mounted for 25/25.5 294mm bsl length and went down a full boot size (284bsl). current mount wouldn't work and remounting at center the holes were too close. ended up re-mounting with attacks and was perfectly fine....you should be good
Click to expand...

looking at the pdf of the template overlap it looks like it’s possible with about 4mm of clearance between screw holes only moving my mount position a couple of mm but not sure if the shop will let their tech mount them that close
 
14391661:KCoCM said:
looking at the pdf of the template overlap it looks like it’s possible with about 4mm of clearance between screw holes only moving my mount position a couple of mm but not sure if the shop will let their tech mount them that close
Click to expand...

See if you can get closer to a cm. Moving the mount back (or forward provided they aren't center mounted already) a cm or two isn't going to have a huge impact.
 
The toe holes will be the only thing that might make you move +/- 1cm. Pivot heel holes never really get in the way in my experience
 
You must log in or register to reply here.
Back
Top