Recent content by Julius_Steezer

It's a long shot but here goes... I got into park skiing around 2014 and remember watching an edit which I guess would've been in the 2013 - 16 timeframe. I woke up this morning suddenly remembering how stoked I was on this edit and wanting to watch it again but I can't find it (mostly as I...

probably should’ve posted this during winter but whatever…I spent an afternoon trying to get lazy 3s down. I got a few clips where I got close but from the side on clip, I’m basically landing in the same way I took off which isn’t ideal. Other than a bigger jump which I know I need to take it...

Just come back from a ski trip and noticed that the right 1/3rd of my heel piece is missing. The heelpiece still seems stable with a boot in and the screws are fine, is there anything to worry about here / has this happened to anybody else or are they fine to ride?

So the plastic bit on the brake arm on my ski has somehow got chipped, leaving a nice pointy bit of metal which is begging to get snagged on whilst riding switch (see pic) Due to a previously broken brake, I have the same plastic part on an unused brake (see picture below). Ideally I want to...

I have an issue where my underfoot sidewall slightly protrudes out from under the top sheet and overhangs the edge slightly. If I try to carve at all then it snags and gets a bit sketch at speed. I can push the sidewall back in but there’s no way to keep it there. Any ideas on how to fix this (I...

I’ve got some ghosts which are pretty old now but I love the fit and was gutted when the model was discontinued. I need some new boots and was looking at the s/pro 120. The last is the same apparently (100) and I’ve found a great deal online. As the shops are all closed due to corona (inb4 see a...

So I’m in the situation where I had to take apart the pivot baseplate a little as my brake got stuck at a bad angle. Long story short, I managed to get both brakes back into the black plate and got the spring under the plate but it wouldn’t stay down. I basically have 2 questions; 1) do any...

Asking for help but could turn into BST. I have some candide 2.0s from 15/16 I think (the white ones with navy blue tips and red writing) which I’m thinking of selling. 1 pivot mount at recommended bsl 305mm but I’m keeping the pivots. How much do you think would be a reasonable ask? Also I’m...

Going out to Tignes / VDI for a week starting 6th Jan. anybody know if either place has a park open that early?

been looking for the black ghosts in my size as my orange ones are looking a bit worse for wear but most of the 18/19 stock is sold out. I couldn’t see anything in the NS gear preview but does anybody know if the ghosts are returning next year?

So I need to adjust my pivots to take a boot which is a couple of mm too long for the current setup (so it’s within range). Looking at some other threads, people are advising not to do it if you have no clue or you could end in getting a remount. Is there much more to it than just incrementally...

So I dinged my base over a rock and now it is extruding out a bit. The edge seems to be ok but does anybody have advise as to what I could do to sort the affected base area out to stop water getting in? Cheers

Going to try Lincolns this winter. Whenever I do them on a diving board/tramp, I can get the rotation round fine but I never land on my feet and stick it as I’m off balance. Does being on skis make it any easier? In my head it seems that it’ll be harder than a backy as you only have the width of...

So I have an old helmet which has no cracks or anything but the inner foam slides around under the plastic (it doesn’t fall out, just moves a cm or so if you jiggle it). Safety concerns aside (I’m rarely going to use this lid, more as a backup so I’m not going to wear this for anything sketch)...

Other than graphics, have there been any changes from last years twall to this years? Just wondering as I’ve found a good deal on last years and wanted to see if there were any noticeable differences